分析模組

AUTO-Analysis is a set of tools specifically developed to allow you to quickly analyse a component and check for any possible situation.

The Comparison tool will allow you to check two different models and quickly see and possible modifications using a graphical interface.

The Draft Analysis tool will allow you to check any model for draft conditions using a user specified angle range. This tool can also be used to graphically show a set of iso- curves checking the 'flow' of a set of faces.

The Smooth Edge tool will allow you to check for tangency on any edge within a user defined tolerance.

The AUTO-Split tool will automatically identify TOP, BOTTOM, SPLIT, VERTICAL and UNDERCUT faces and allow the user to modify the face directions and graphically simulate the component splitting. The animation can also be saved as a XML file for later viewing or the show that important customer.

The Split Line manager will identify the computer defined parting line, but also allow dynamic user interaction to manipulate or modify the parting line. Simulation of the component splitting is also possible using this tool.

Within the AUTO-Analysis suite there are also the options to automatically create parting faces, detect redundant bodies, automatically fill holes on faces, check for solids interference and display all relevant workplane rotation and translation values.

 
Details that count :

The Comparison tool will allow you to check two different models and quickly see and possible modifications using a graphical interface.

The Draft Analysis tool will allow you to check any model for draft conditions using a user specified angle range. This tool can also be used to graphically show a set of iso- curves checking the 'flow' of a set of faces.

Iso-Curves displayed to check the 'flow' of a set of surfaces or faces.

The Split Line manager will identify the computer defined parting line, but also allow dynamic user interaction to manipulate or modify the parting line. Simulation of the component splitting is also possible using this tool.

The AUTO-Split tool will automatically identify TOP, BOTTOM, SPLIT, VERTICAL and UNDERCUT faces and allow the user to modify the face directions and graphically simulate the component splitting. The animation can also be saved as a XML file for later viewing or the show that all important customer.


 
2D設計模組
3D實體模組
分析模組
電極模組
塑膠模座模組
沖壓模座模組
2D加工模組
3D加工模組
5軸加工模組
刀具路徑總管
高速加工模組
彩現模組
線切割模組
板金展開模組
本站最佳瀏覽視窗為1024*768
昱網科技股份有限公司 版權所有Copyright 2004
807高雄市三民區民族一路80號33F之2 / TEL:(07)226-6666 FAX:(07)226-3666
如有任何問題歡迎你與我們聯絡:info@sunspot.com.tw